ELM 327 1.3 can line problem

[ivica21]

Hello
Today i received my fourth elm327 1.3 and can line not work.I dont know what is the problem.I use registered version of fiatecu.

[Jerry 159]

I have the bottom interface, and its working OK for me.

Have you installed the driver and selected the right comport?

[ivica21]

Yes.I instaled drivers and select port and baudrate.What version of drivers you have?
I can conect to engine but dashboard and service reset not work.

[ivica21]

When i plug in car Blue interface, lamp for petrol is blinking.Maybe the wires in interface not corectly soldered.

[ivica21]

Today i received my 5-th elm327 with original 1.4 ic from skpang.Only this work perfect with can line.Other 4 elm327 1.3a from china is defected or bad clone.

[mattydr67]

I opened up my interface and I looked.
I have the bottom blue one.
The soldering are the same like your.

[TribesMan]

Mine is also the same as the bottom one... works OK.

[alfa156sarajevo]

Today i received my 5-th elm327 with original 1.4 ic from skpang.Only this work perfect with can line.Other 4 elm327 1.3a from china is defected or bad clone.

just one question: where did you bought this interface? eBay or???

[ivica21]

Yes from ebay and china.Only original elm327 from skpang works fine.Today i solder elm327 1.4 ic on interface from Serbia and k-line and can line works fine.

[alfa156sarajevo]

many thanks for this info!

do you by any chance have eBay link from skpang?

cheers mate