Fiat 500 2018 with ecu 9gf. Car start and cut after few seconds

[didi_du_93000]

Hi I have a Fiat 500 from 2018. It starts and for 5 seconds and stop. if I hold the accelerator it stays started for about 20 seconds. I put back a blank calculator which was autocode and I have same problem.
Any anyone know the problem?

Thanks in advance.

[abarthmultijet]

Any fault codes stored?

[didi_du_93000]

Problem solved, an massa broken in car.

It's back from thief. So we have changed the BCM with second hand because original is missing.


I have virgin ECU motor, adapter to car.

Now i have mil blinking in dashboard due to proxy aligment. I have do it but i have always error on the ETM (entertainment telematic node).


How can i do to make working?

Regards,

[abarthmultijet]

You can obtain the original radio code via the interweb, quite a few websites who do radio codes.

Can you upload the current proxy?

[didi_du_93000]

I have pin code of the radio.

I have changed the bsi.

This is the log and hex proxi backup.

[abarthmultijet]

Only error with ETM when doing allignment?

[didi_du_93000]

Yes

[abarthmultijet]

And any fault codes in ETM?