Alfa Giulietta cannot calibrate Xenon Headlights

[Ruggero1912]

Good morning everyone.
I have an Alfa Giulietta 2.0 with original Xenon Headlights pack.

I noticed that the beam lights are facing too downwards.

For this reason I tried to calibrate the Xenon unit from MES, but it returns me an error, even though I placed the Giulietta in the required conditions (flat surface, no one in the car, low beams turned on).

In the following image I reported a screenshot showing the values read from MES.

I have the doubt that the pitch is not correct, but I am not sure about that, what is considered a correct value when the car is on flat ground?

Do you know what component could cause wrong measurements of this value?

IMG-20240828-WA0006.jpg (315.53 KiB) Viewed 2697 times

Thanks for your attention

[shpuncik]

check sensors physically if they are OK. voltages don't look correct.

[Ruggero1912]

check sensors physically if they are OK. voltages don't look correct.

Thanks, I will check it