FIAT PUNTO EVO - 2011

[jln]

Hello,



I change my motor oil, and i would like erase the red led "oil motor" from my dashboard.
I buy a Yellow cable and a Bluetooth "OBDII SCANNER". I remove a resistor between pin 6 and pin 14.
I have a ECU Communicaton problem.

Can you help me?

[alfa156sarajevo]

Hi,

First of all go to Settings> Interface> Type of interface> select "ELM 327 v1.3+ (Bluetooth)"
Do not use your interface as OBD Key 1.40 (Bluetooth).

Second of all try to change speed. In the same window Settings> Interface> Speed> select "38400" speed and try.
In general speed 38400 is common speed for all cable interfaces and speed for BT interfaces iz 115200.

[jln]

"ELM 327 v1.3+ (Bluetooth)"
select "38400" .

Thanks you with these parameters, i can connect to ECU.
It's work good.


Now i have a another problem.
I make a service reset, but the red ligt is allows on my dashoard.


The service reset put 63768km in "DISTANCE AFTER LAST SERVICE".
I think i need to put 0km on this parameter? Yes - No?
If yes, In the Tab '"Adjustement i can't write this parameter?
How to resolve this issue.

[alfa156sarajevo]

OK! Here is solution.
When you are trying to reset OIL service light on ALL Italian diesel MJET cars you have to do next:
- select Engine > then "type of engine" > than F7 (settings) > then select "oil change version with DPF" > click F10 (execute);
- select service > than "service interval" > than F7 (settings) > then select "next service KM reset" > click F10 (execute).

You have to reset service message always on 2 separate ECUs. See photo.

[jln]

Thanks you for your help.

In Engine, I tried to execute "oil change version with DPF", but i have a error

[alfa156sarajevo]

Try with newer version of MES...

[tomas]

Interface> Speed> select "38400" speed and try. In general speed 38400 is common speed for all cable interfaces and speed for BT interfaces iz 115200.

Diablo 3 Gold

Buy Diablo 3 Gold http://www.diablo3fast.com/