Bluetooth Elm issues

[saintetienne]

Good evening everyone ,

I recently bought a bluetooth elm interface ( think it may be a 1.4 ) to access some info on my daughter's brera and reset oil message after I had serviced -it shows as connected and during tests pass all parts - however I can only get connection to main engine ecu - I had a brief look on here last night and say a post regarding removing a resistor to access can line , looked on here again tonight and can't find it - anyone know of this ?

thanks

[Alfaeddy]

Hello

The others on ABS to control and xenon are all read by CAN bus, and to many ELM interface, a resistor must be removed.
Of the CAN bus signal interferes

For ABS and Xenon you need adapter cables or your ELM must be rebuilt.

The matter with the Resistor find more

viewtopic.php?f=5&t=1493

Greetings Eddy

[saintetienne]

Hi Eddy ,

thanks for the reply - I have taken my interface apart and it looks quite different maybe cos it's a bluetooth one - do you think this can be modified or should I buy a better one ?

thanks

20130104_170151 (Small).jpg (141.95 KiB) Viewed 3480 times

20130104_170530 (Small).jpg (122.24 KiB) Viewed 3480 times

20130105_171540 (Small).jpg (152.19 KiB) Viewed 3478 times

[Alfaeddy]

Hello Saint Etienne

I marked in red the resistor to be removed .
Remove this and then your ELM also works in the CAN bus protocol

20130105_171540 (Small) markiert.jpg (152.02 KiB) Viewed 3474 times

Greetings Eddy

[saintetienne]

I will do that tomorrow ,

many thanks

[saintetienne]

Eddy , thanks a million - up and running !

[Alfaeddy]

Hello

Nice that I could help you

Greetings Eddy