No connection! Fiat Coupe 20VT Bosch Motornic M2.10.4

[yotein]

Hi!

I have problems to connect the Engine ECU.
Multiecuscan tells me I need the registered Version, is that correct?
Ctrl+F10 for simulation works.

What am I doing wrong?

Many thanks!

Rolf

[alfa156sarajevo]

You need a registration key to read all parameters from engine ecu.

On this web page you can see that "Bosch Motornic M2.10.42 is marked in red:
http://www.multiecuscan.net/SupportedVehiclesList.aspx

Modules in red are supported by the REGISTERED version only!

[yotein]

ah...
ok, thank you for your reply

[mattnunns]

Hi Yotein,

Did you manage to get a connection? I've got the Fiat Bravo HGT 147 2.0 20v with the Bosh Motronic M2.10.4, I cant get any connection at all, what symptoms were you getting?

Which cables are you using? I have the KKl cable and a 3 pin adapter but dont even get a connection.

[Ismo]

Hi,

Same here, no connection.
I Have Fiat Coupe 2.0 20V Turbo -98

Fiat Ecu Scan says that I need K-Line/Vagcomm/Odbkey to connect this module...

So, can I then get connection with this one? as this is Vagcomm?:

http://cgi.ebay.com.sg/DIAGNOSTIC-CABLE ... 2116wt_937

I have now this one and it works fine with Fiat Stilo 1.2 16V -03 and Citroen C2 1.4 VTR -03:

http://cgi.ebay.com.sg/AUTO-SCANNER-OBD ... 2313wt_905

EDIT: When I change at the Multiecuscan settings to Vagcom/KKL, I will get No response from ECU message.
I am not sure does my scanner support KKL as does not say anywhere, should I buy the Vagcom scanner?


Regards,

Ismo

[alfa156sarajevo]

@ Ismo
I think that web link for VAG COM 409.1 showen above should work with Fiat Coupe 2.0 20V Turbo '98.
Looks OK!

[Ismo]

@ Ismo
I think that web link for VAG COM 409.1 showen above should work with Fiat Coupe 2.0 20V Turbo '98.
Looks OK!

Thanks, I'll buy that!


Ismo