ME 2.1,ME3.1,Xenon Adjustment and Automatic Gear 166

[frank37]

Hello Yani,

please support for 166 ME 2.1,ME3.1 ECU, Xenon Adjustment and Automatic Gear.

thx
Frank

[klimekkk]

Hello,
What you mean by xenon adjustment? Is this possible by ECU?
I adjusted manualy in my Alfa 166 - you have to use hex (6mm?) key and turn screw on top of electric motor - it's huge regulation this way!

[frank37]

for Xenon is adjusted via the diagnostic plug, there was no bolt on the motor.

frank

[klimekkk]

Hmmm. If You talking about bixenons it may be correct. Xenon before FL has manual regulation by this bolt: http://img689.imageshack.us/img689/6144/xenon2xi.jpg

[frank37]

Yes, but Xenon is adjusted via the diagnostic plug and the Fiat Examiner.

Frank

[devc]

The ME 2.1 is the same as the ME 7.3.1 but without the two Lambda sensors in the exhaust branches (Bank1 & Bank2)
All the other sensors & Actuators are the same. Pre 03 156 2.5V6 (ME 2.1) & post 03 156 2.5V6(ME7.3.1)
The same diagnostic can be used.

[156V6]

The ME 2.1 is the same as the ME 7.3.1 but without the two Lambda sensors in the exhaust branches (Bank1 & Bank2)
All the other sensors & Actuators are the same. Pre 03 156 2.5V6 (ME 2.1) & post 03 156 2.5V6(ME7.3.1)
The same diagnostic can be used.

Does that effectively mean I could pick any of the cars listed that use the 7.3.1 ECU to communicate with my 2.1 ECU?

[Nilsx]

The ME 2.1 is the same as the ME 7.3.1 but without the two Lambda sensors in the exhaust branches (Bank1 & Bank2)
All the other sensors & Actuators are the same. Pre 03 156 2.5V6 (ME 2.1) & post 03 156 2.5V6(ME7.3.1)
The same diagnostic can be used.

Does that effectively mean I could pick any of the cars listed that use the 7.3.1 ECU to communicate with my 2.1 ECU?

Yes, that'll work. I used the GTA ECU, you'll only get a warning about the ISO code.

But i would also like to see specific support for the ME 2.1 ECU.