Multiecuscan 2.6.1 RELEASED!

[yani]

Hi,

I released version 2.6.1 today. It is a release that fixes a number of problems from version 2.6.
- Fixed the problems with Grande Punto, 500, MITO, Punto Evo support. It was not working with some ELM interfaces.
- Fixed a few problems in PROXI Alignment (CAN Setup) Procedure. It was working only in english and it failed on some vehicles
- Added CAN Info function for Grande Punto, 500, MITO, Punto Evo.
- Fixed a problem with VagCom interfaces. This problem was caused by the speed improvements in version 2.6.

Yani

[sa80libero]

adesso dovrebbe funzionare sulle grande punto, grandepunto evo ecc?


Now it should work great on point, etc. grandepunto evo?

[cicus]

yes but to work fine with service interval reset with some elm interface you need to move pin 6 &14 to 1 & 9...but i don't know how to do..

[zippo]

When you say -...not working with some elm 327 interface, you mean the fake that need capacitor-resistor soldering or you mean other?
Thanks.

[alfa156sarajevo]

yes but to work fine with service interval reset with some elm interface you need to move pin 6 &14 to 1 & 9...but i don't know how to do..

more info you can find here: viewtopic.php?f=6&t=1692&start=30
to find this topic just go to: Board index ‹ General ‹ Multiecuscan 2.6 RELEASED!