Fiat Ducato Remove Driver Assistant System Node (DASM)

[linknet]

I have a 2022 Fiat Ducato and it has the Driver Assistant System Node (DASM) which was purchased as an extra on the new vehicle. This module has given many problems which, as yet, Fiat have been unable to solve.

I would like to remove it using MultiEcuScan. I would appreciate any advice on this.

If I run a proxi alignment and disable that module would that work or would I have to physically remove the module which I understand to be integrated within the HALF Lane Sensing Camera?

[kevin2008]

yes, very good question. you have test ?

[didi_du_93000]

Hello,

I have Fiat Tipo MK2.

I have removed the DASM from node.

Proxy alig is ok, DASM is disconnected. and have put in prox adaptation the standar regulator (foriginal value is ACC).

Now i have ESP light on dash, and some message from ABS/ESP too.

Any change to resolve the problem? need to code/adapt ABS modul?

Regards,

[shpuncik]

Hello,

I have Fiat Tipo MK2.

I have removed the DASM from node.

Proxy alig is ok, DASM is disconnected. and have put in prox adaptation the standar regulator (foriginal value is ACC).

Now i have ESP light on dash, and some message from ABS/ESP too.

Any change to resolve the problem? need to code/adapt ABS modul?

Regards,

try performing lateral/longitudinal sensor calibration in ABS ECU. see if it will solve you problem.