My 2020 Ducato Euro6d 180bhp ISO Codes

[RoloPolo]

Hi all

These two codes are not recognised on the latest version (uninstalled back to my previous licensed version so I can do basic adjustments)

Will purchase new license once vans recognised

Engine/ecm 0001 50 6A 16 unknown/ unsupported

ABS etc
Unknown unsupported
0006 50 65 16

MY 2020 Ducato L4 H3 manual 2.3 180 euro 6d (adblu)
Cheers

[Grayducato]

Hi Rolopolo

I have just registered as a new user, and have the same problem as you had. I'm not sure if you are still in the forum, but I need a solution. My vehicle is a Ducato 2.3 series 7 2021 build, euro 6D 9 speed auto with Adblue.

I get an ECU not recognised message when I start MES, but all other modules connect OK. My vehicle has been into a Fiat workshop for PM sensor replacement and it was during this time that the ECU was flashed to accommodate the new (Bosch) sensor. This caused a change in the ECU ISO identifier.

I hope you can help, it has been a while since you posted. Do you know how often MES updates their vehicle ISO database?

Thanks

[abarthmultijet]

Probally will be in the next MES version, new versions come out sometimes in half a year and sometimes a year. You can check the history here: https://www.multiecuscan.net/ReleaseHistory.aspx

[Grayducato]

Thank you, Abarthmultijet, the link you posted to the MES update history is excellent. It shows an active updates cycle with unknown ISO codes being added with each release.

I only have the Demo version of 5.3 and would like to see this resolved before I purchase.

Do I need to inform MES of my ISO code to include in a future release? or will MES already have a full list of codes to be added?

How would I inform MES if that is necessary?

Cheers

[s130]

Send an Email to support@multiecuscan.net quoting your vehicle, ECU and ISO code.

I don't know how they get new/updated ISO codes so dropping them an EMail will do not harm.

[Grayducato]

Thanks s130,

I did that yesterday after advice from other forum members also, I appreciate your reply too, I can but hope...

Cheers,

Graham in Au