ABS actuator test

[ttlogan]

Actuator tests do not work in the ABS!
(Fiat Stilo 1.4)

[yani]

Hi,

Which type of ABS do you have?

Please note that some tests require the engine to be running while others require the engine to be stopped.

Yani

[ttlogan]

HI Yani!

My ABS type Bosch ABS 8!
Test does not allow any,but I'll try again tomorrow!
Have any idea what could be the problem?

[ttlogan]

It is only natural to connect TO THE ABS with EBD FAILURE and ABS FAILURE
message to the instrument panel display?

[ttlogan]

Hi!

Today I tried again, but it does not work either in Actuator test!
Regardless of whether the engine is running or stopped!

[yani]

Does it give you an error message?
Or, it runs but nothing happens?

What type of interface do you use (VagCom or ELM)?

Yani

[ttlogan]

Hi Yani!

Modified Vagcom cable!
Error message: Failed to execute

The lower left corner: Sometimes too high Latency

Is the port settings for me "1" latency

[lybra2.4jtd]

Hi Yani!
I have a vag-com cable and I successfully connect with ABS ECU. But shows the errors for ABS and EBD failure message to the instrument panel display. When I disconnect the ECU, the errors disappear.
Why this happened? What is wrong
Thanks for help.

[yani]

Hi Yani!
I have a vag-com cable and I successfully connect with ABS ECU. But shows the errors for ABS and EBD failure message to the instrument panel display. When I disconnect the ECU, the errors disappear.
Why this happened? What is wrong
Thanks for help.

That is normal. There is nothing wrong.

[adibadi]

Hi!
I have a 1.4 8v Fiat Albea. I can connect to the ABS, read parameters but can't test any of the actuators. Appears to be doing but nothing happens, there is no sound nor any solenoid and the pump motor. KKL interface modified and Bosch ABS 5.3.
Regards from Romania!