multiecuscan miultiplexed

[Miguel130281]

hello, i received a multiecuscan miultiplexed, last week and i can't connect my car to it, Alfa Romeo 147 16V Q2, i install all software, even when i search connexions type it find it and says it's compatible, only when i try to connect to the ecu car it won't it says connection not find check cable. what i'm i doing wrong? when i test it, it shows:
COMMAND: ATZ
RESPONSE: ATZ


MultiECUScan (FiatECUScan v3.4+)

>

COMMAND: ATI
RESPONSE: ATI
MultiECUScan (FiatECUScan v3.4+)

>

COMMAND: ATE0
RESPONSE: ATE0
OK

>

COMMAND: ATL0
RESPONSE:
OK

>

COMMAND: ATH0
RESPONSE: OK

>

COMMAND: ATSPC
RESPONSE: OK

>

COMMAND: ATS0
RESPONSE: OK

>

COMMAND: ATCAF0
RESPONSE: OK

>

COMMAND: ATCFC0
RESPONSE: OK

>

COMMAND: ATCRA 7B0
RESPONSE: OK

>

COMMAND: ATSH 7B0
RESPONSE: OK

>

COMMAND: ATAT1
RESPONSE: OK

>

COMMAND: ATST41
RESPONSE: OK

>

COMMAND: ATBI
RESPONSE: OK

>

This interface is compatible with ELM 327 1.4! Should connect properly with all CAN modules.




but when i try to connect the ecu it won't do it!
thanks

[Miguel130281]

Have someone has the same problem connecting cantiecar? I 've found the problem, i have to push the cantiecar really hard, but the most of the times it won't connect. It's not normal that i should push it really hard to connect.

[alfa156sarajevo]

I also have CTC interface and the same problem with "pushing" the interface in car.
After few cars I decided to use OBD2 extension cable and it is working without problems.
I just have more cables and that is all....