Waltomatic wrote:Exactly, but it's not a "dip switch", it's a "change-over switch", as I said...Alfaeddy wrote:hello
In this ELM all possible circuits are housed in 2 switch positions, there is no need for adapters.
viewtopic.php?f=5&t=4297&p=15111#p15111
Greeting Eddy
So when activated, connect together pin 7 and pin 12 (making a bridge)? I need just to connect to xenon!Alfaeddy wrote:Waltomatic wrote:Exactly, but it's not a "dip switch", it's a "change-over switch", as I said...Alfaeddy wrote:hello
In this ELM all possible circuits are housed in 2 switch positions, there is no need for adapters.
viewtopic.php?f=5&t=4297&p=15111#p15111
Greeting Eddy
But this switch replaces all adapters (A1, A3, A4 purple)
This is a multi-switch
not as the simple CAN bus switching
Greeting Eddy
OK!Alfaeddy wrote:But this switch replaces all adapters (A1, A3, A4 purple)
This is a multi-switch
not as the simple CAN bus switching
Greeting Eddy
I've tried that way, but it don't connect with the xeno ecu...Waltomatic wrote:Racing, you can include 12-7 in it, respecting the disconnection of 7 when linking with 12.
No, according Supported Vehicles you need the same A3. You welded wire on pin 12 of connector?Racing Man wrote:I've tried that way, but it don't connect with the xeno ecu...Waltomatic wrote:Racing, you can include 12-7 in it, respecting the disconnection of 7 when linking with 12.
In normal operation, just switching the wire 7 from pin 7 to pin 12, it doesn't connect... So, seeing adapter #1, where 7, 9, 12, 1 are linked toghether, maybe to connect with xenon pin 7 and 12 must be joint together to wire 7?
No, I've only put a switch on wire 7, that connects pin 7 or pin 12. Should I weld pins 7 and 12 together? Why the same A3? In this picture is shown A1Waltomatic wrote:No, according Supported Vehicles you need the same A3. You welded wire on pin 12 of connector?Racing Man wrote:I've tried that way, but it don't connect with the xeno ecu...Waltomatic wrote:Racing, you can include 12-7 in it, respecting the disconnection of 7 when linking with 12.
In normal operation, just switching the wire 7 from pin 7 to pin 12, it doesn't connect... So, seeing adapter #1, where 7, 9, 12, 1 are linked toghether, maybe to connect with xenon pin 7 and 12 must be joint together to wire 7?
I've written it few pages before, I forgot to repeat it!Waltomatic wrote:Cáspita!!! Você não disse que era do Alfa, kkkkkkk
Meu conselho: esqueça a adaptação para o Alfa e compre um cabo.
