156 GTA Selespeed Clutch degradation Index/Self Calibration

[maxbg]

Hi Guys!

I just purchased my multiecuscan and would like to find out how to perform the following procedure for my GTA selespeed...

1) Clutch Degradation Index recalculation
2) Clutch Self Calibration
3) End of Line

Are the above process necessary for a new clutch replacement or are there more steps required?

Any response is greatly appreciated!

[maxbg]

Any response will be greatly appreciated!

[Alfaeddy]

Hello

About the exact function of the Selespeed is well known from Belli
on his website you can find a lot to

http://www.selespeed.de/


Greetings Eddy

[maxbg]

Hello

About the exact function of the Selespeed is well known from Belli
on his website you can find a lot to

http://www.selespeed.de/


Greetings Eddy

Thanks for the suggestion. I managed to perform all except the clutch self calibration procedure.

The multi edu scan always show "not performed" even after following the instruction given by the software closely.

any assistance is appreciated!

[gbernard]

BUMP

, same issue here with my 147 GTA selespeed

any instructions or advice from anyone who has performed it correctly I am using a registered MES 2.3R2.

[Alfaeddy]

Hi

The clutch calibration is carried out according to the instructions in the right frame.

Only after the termination of the proceedings acknowledgment arrives for the implementation

Greeting Eddy

Selespeed GTA.jpg (94.43 KiB) Viewed 4850 times