Cannot Access Airbags for 1.6 Stilo - Have correct interface

[BurkeyL]

Hi,

I just bought the complete recommended cable set - ELM 327 with the different colored adapteres -red, yellow, green and the blue vag kkl -

I cannot connect to the Airbag control for my 2002 stilo 1.6. I have installed it correctly, and the driver....Have changed the latency as per the pdf "how to use" guide.

If it was cheap ebay cables I would understand but I bought them here http://www.idiagnostics.co.uk/ - it states 100% coverage for MultiECUScan.

Any ideas?

[Alfaeddy]

Hello

You need for your airbag control unit, a KKL interface!
and the red Adapter
With the ELM you can read on the silo no airbag

Greetings Eddy

[BurkeyL]

Figured out you use the vag kkl and red adapter, not the ELM. Pretty crap instructions all round. Good software though.

[s130]

The Supported Vehicle Table clearly states to use KL3 (KL 3 - KKL/VagCom interface with ADAPTER CABLE 2 (or modified interface with K-line connected to pin 3)) and A2 (adapter cable 2).

Also the software does tell when you select the Air Bag system to "CONNECT ADAPTOR2/RED (OR PIN3)" and "PRESS Y TO CONFIRM".

All pretty clear to me.

I'll grant you the software could have said "USE KKL INTERFACE AND CONNECT ADAPTOR2/RED (OR PIN3)" and "PRESS Y TO CONFIRM" so maybe this is something that can be changed.