Punto '99 1.216V no ECU response

[oz42]

Tried FES 1.3 today, still no luck. F11 searches for a while and finds nothing.

On the ECU I read the label ME73 M003 - I think. Old eyes, dm light and tiny characters on the label.
Which of both available ECUs should I select then?

Olaf

[Alfaeddy]

Hello Olaf

For ME7.3 you need the registered version
I am surprised that the old FES Verison 1.3, this control has ME7.3 in the program?

Can you make a connection (adapter A2) to the airbag?
As already wrote alfa156sarajevo

This should go well with the unregistered version of FES.

Greetings Eddy

[oz42]

Sorry for the confusion, I meant: I tried MES 1.3 today, not FES. About airbag: I will have to modify the KKL interface before which I won't do today.

Thank you for helping!

[Alfaeddy]

Hello

Or you buy this one

http://www.ebay.de/itm/150964798218?ssP ... 1438.l2649


Greetings Eddy

[oz42]

I disconnected pin 7 and connected the board to pin3. Result: the interface is not detected anymore.

[Alfaeddy]

Hello

Strange?
After this assignment, you should only be able to read on your airbag.

It may be broke in changing?
some do a test
Multiecuscan / Settings / Interface / K-Line VAG (test)

Greetings Eddy

[oz42]

I just changed the lower lambda probe and tried to clear the MIL with my generic scanner.

It did not find the ECU...

I disconnected the battery and checked all three ECU fuses, they are okay.

After reconnecting the battery, my generic scanner found my ECU again.

About MES: Multiecuscan / Settings / Interface displayed no interfaces.

[Alfaeddy]

Hello

If you changed the connection from pin 7 to pin 3, you can´t make a connection to your ECU!!
But only to the airbag!

your message
About MES: Multiecuscan / Settings / Interface displayed no interfaces.

IT must of course the correct com port and interface have been set!
Otherwise Multecuscan not work with the interface

Greetings Eddy