Dear community
Let me introduce myself quickly.
My name is Marcel and I am a - proud
- owner of an Alfa 159 TBi.
Have started to play recently with an ELM 327 ( rev 1.5) interface on my car.
Here is my issue:
During the SCAN (F11) I don't see the engine ECU of my car ( should be a Motronic). All other modules show up (steering lock, body ECU ... c.f. attached).
I would expect that the engine ECU also shows up during the scan, even if I cannot connect properly because I use the free version of multiecuscan.
Can somebody confirm that, or is that a problem sombody else has already had ?
My plan is to purchase the registered version of Mutiecuscan, but I want to make sure that there is not a problem somewhere else.
Note that I have tested my interface on a Lancia Musa 1.3 and it seems to work fine ( can access all items that are supported by the free version).
Also latency time of the com interface has been set to 1. Baud rate 38400.
Here are the results of the scan:
Scanning ...
Electric SteeringSteering Lock TRWISO Code: 04 07 04 04 68BodyBody Computer MarelliISO Code: 40 83 1F 04 3BBodyTEG Reader TRW (Electronic key)ISO Code: 6E 07 01 04 4FDashboardInstrument Panel SiemensISO Code: 32 83 9E 04 2CDashboardConvergence Marelli/Microsoft C3 (Blue&Me Nav)ISO Code: B5 83 8C 85 9EClimate controlDelphi climate control (Dual/three zone)ISO Code: 34 83 0B 04 9BOtherDriver's Door G.E. PROCONDISO Code: 86 07 8C 04 F2OtherPassenger's Door G.E. PROCONDISO Code: 89 07 08 04 F1OtherBoot G.E. PROCONDISO Code: 07 07 08 04 EFOtherParking Control VALEOISO Code: 3E 83 83 01 1A
COMPLETED
Feedback is much appreciated.
Thx !
