Multiecuscan

Hi Yani,

I have an ELM327 clone.
My problem, that I can connect with this ELM only to the ECU of engine. The other connections (service reset, etc.) aren't estabilished.
Help Me, please!

Joseph

Here are the multiecuscan's test results:

COMMAND: ATZ
RESPONSE: ELM327 v1.5a>

COMMAND: ATE0
RESPONSE: ATE0OK>

COMMAND: ATL0
RESPONSE: OK>

COMMAND: ATH0
RESPONSE: OK>

COMMAND: ATSPC
RESPONSE: OK>

COMMAND: ATS0
RESPONSE: ?>

COMMAND: ATCAF0
RESPONSE: OK>

COMMAND: ATCFC0
RESPONSE: OK>

COMMAND: ATCRA 7B0
RESPONSE: ?>

COMMAND: ATSH 7B0
RESPONSE: OK>

COMMAND: ATAT1
RESPONSE: OK>

COMMAND: ATST41
RESPONSE: OK>

COMMAND: ATZ
RESPONSE: ELM327 v1.5a>

Your ELM interface does not support v1.3 commands. It will not work.

Yani

Thanks!
It is nice.
I read on this site, that "You need to have a k-line (VagCom) or ELM 327 v1.3 (or later) interface cable in order to use this program."
What is the reason? Because it is a clone, or I have wrong version? The v1.5a is not a later version of v1.3?

joseph67 wrote:The v1.5a is not a later version of v1.3?

Well, in this case, it is not.
Your interface actually seems to be v1.2.

Yani

The 1.5a interface is a fake...

Lastest is 1.4 but is very difficult to find. (because 1.4 specification has been released just a couple of months ago.)
So, lastest that you can buy is 1.3