Multiecuscan

Hi,

I have been trying to enable Xenons on my Stelvio.

I have changed the setting in the MES and successfully run a proxi config.

However the DRL and indicators are not working - I have checked the light and it ok and the connector is fine.

I can only assume that the change is not taking affect after the proxi and the BCM is not connecting to the LEDS

Any suggestions on what I may have missed?

Thanks

Frank

wiring is different between halogen and xenon headlights

Hi,

The wiring is the same
the xenon lights work fine.
The LED's do not when when I checked the voltage at the pin it drops when the LEDS are plugged in.

I suspect the BCM is not picking up the changes but this is me having a guess.

Thanks

Frank

Hi!
Wiring is not same!
You have to add 2 wires for both lamps to activate DRL and for correct function of turning lights...
Then you have to change proxi settings...
Good luck!

Hi,

Can you elaborate about the wires?
I have checked the power at the connectors and can see power there.
I have attached the picture of the connector

My understanding is these are the connectors
1– Low beam positive control . 8 – NA.
2 – DRL/side Marker Lamp Positive Control 9 – Vertical Adjustment Motor Positive Control
3 – DRL/side Marker Lamp Signal 10 – NA.
4 – Direction Indicator Lamp Positive Control 11 – NA.
5 – High Beam Positive Control 12 – Vertical Adjustment Motor Signal
6 – NA. 13 – Ground
7 – NA. 14 – Ground

Also what proxi change is there I can only see the xenon and the shutter ti chnage?

Thanks

Frank