Greetings
Recently I've replaced my clutch, flywheel, rear main seal and more, car engages gears very well but once you press the acc pedal it jerks a little and the rpm needs to be high so i starts driving. I've performed the clutch drain (Million times) and EOL calibration, but i can't reset my Degradation index (12130).
When I execute the "Clutch degradation index calculation" shows me "FF" and when i try the "Clutch self calibration" shows me 0F and on parameters "not performed", i'm following the procedures like described in the right box.
Is there any way of adjust the biting point on the clutch on these system?
How can i adjust the degradation index?
Thank you so much my friends.