Multiecuscan

Hello
I have a problem with Multiecuscan 4.6R1 on a Fiat 500 MY2019
I cannot edit the custom proxy
I go to the proxy alignment procedure, then I do "ctrl / Alt / C" but nothing happens

Is it possible that it does not work on some versions ?

Thank you

check in your MES folder if there is FESLog file generated after you connect and disconnect to/from CAN Setup/Proxi and what is inside.

yes ! ... I found plenty ...
what is the reverse procedure, ie how to save in the ECU a FESLog file that has been modified?

thank you

jpp wrote: ↑19 Apr 2021, 12:58 what is the reverse procedure, ie how to save in the ECU a FESLog file that has been modified?

through ctrl+alt+c

OK,
What is the exact syntax for the upload file ?
Only one line for the proxy in a file called FESLog.txt ?
thanks

jpp wrote: ↑20 Apr 2021, 07:20 OK,
What is the exact syntax for the upload file ?
Only one line for the proxy in a file called FESLog.txt ?
thanks

you can't upload file. you can edit proxi just as you described. if it's not working then most likely not yet supported.

I have the original proxy available in the first FESLog file (this proxy was OK no error and no problem)
I have changed in MES navigation: Not present ==> present
then Proxy alignment ==> Error (probablby because not supported)
Then back to Navigation : present ==> Not present
and then Proxy alignment ==> Error (don't undersant why)

Thus I would like to edit the proxy in order to return to the first configuration which was OK but with ctrl+alt+C nothing happen
and I d'ont know what to do