Multiecuscan

Hey,

At some point I will probably need to connect to my ECU to check for faults and I would like to be prepared for when I need to do this! I have downloaded the Multiecuscan 2.1 software and installed it. My question is I only have "ABS" and "Airbag" under the available systems to connect to for my car. Shouldn't there be "Engine" too?

Thanks

Hello Kelvin,
If you can't see Engine ECU listed under your car - it's obviously that your car engine ECU ( MED7.11 i'm not 100% sure ) is not supported yet.
Be patient please.
Regards
Stefan

Hey there,

Ok fair enough, that did not occur to me sorry! I will be patient