Alfa 156 2.0 JTS

[Kelvin]

Hey,

At some point I will probably need to connect to my ECU to check for faults and I would like to be prepared for when I need to do this! I have downloaded the Multiecuscan 2.1 software and installed it. My question is I only have "ABS" and "Airbag" under the available systems to connect to for my car. Shouldn't there be "Engine" too?

Thanks

[pr_00f]

Hello Kelvin,
If you can't see Engine ECU listed under your car - it's obviously that your car engine ECU ( MED7.11 i'm not 100% sure ) is not supported yet.
Be patient please.
Regards
Stefan

[Kelvin]

Hey there,

Ok fair enough, that did not occur to me sorry! I will be patient