Multiecuscan

Hello,

I have the software "Multiecuscan 2.3R2 Registered". Connection on my Multipla '02 BiPower/GPower using my no name OBD II diagnose interface "1A-Diag" is established successfully. It says that it is a "ELM327". I can communicate with the enigne ecu "Magneti Marelli IAE 4AF/FEF GAS Injection".

When I try to access the airbag control module "Siemens MY99 Airbag" it says "connect adapter 2/RED (or pin 3)". I now ordered a "Fiat 3 Pin OBDII OBD2 Plug Diagnose Adapter Kabel Stecker Alfa Romeo Lancia" from ebay. My problem now is, that I don't know where to connect this to. I can't locate where to plug it in.

Can anyone help me?

Thx!

Of course, read this... http://www.multiecuscan.net/SupportedVehiclesList.aspx

Airbag = KKL <> ELM

Hello Fiatmultipla

The ELM interface readout is not possible


When the red adapter (A2) is required.
Is only one KKL or OBDkey to use.

Never ELM Interface

Greeting Eddy