Multiecuscan

Hi guys!
I am trying to connect to my Punto's ECU to check errors and etc. My car is: Fiat Punto ELX, 1998, 1.2, 85HP, 16V
I have these two cables that are connected to the 3pin port next to my ECU.
http://www.ebay.com/itm/New-Mini-OBD2-E ... 4d1cfd325e
&
http://www.ebay.com/itm/3-Pin-to-16-Pin ... 27c9ff88d0
On the other side i use laptop with bluetooth connection (Bluesoleil) to conect to the cables.
Then i use Multiecuscan (free) to try to connect to the ECU but i never manage to
So my question is can i use these cables to connect and if yes - what settings should i use, or i should buy KKL cable like this and then try again:
http://www.ebay.com/sch/i.html?_sacat=0 ... om&_sop=15
Thanks for your time and have a wonderful day

Hi

This is your Punto, right?
There is yes you need a KKL interface
with the ELM interface, you can not do anything

Buy yourself the KKL from your link and you'll be able to connect

But you need the registered version to your engine control unit to correctly read.

Greetings Eddy