Multiecuscan

Hello Yani,

I was trying to deactivate the Emergency Stop Signal ESS (Blinking of indicators when you hard press the brake).
I thought it was a function in ECU, but unfortunately it is not.

The ESS will be handled by the Body Computer.

The BC monitors following conditions:

- deceleration >7 m/s² (+/-0,5 m/s²)
- vehicle speed >50 km/h
- no blinking light active
- vehicle speed sensor not damaged

If all of these conditions are true, BC will start sending the signal for ESS.
They will blink with a higher frequency than normal blinking.

If BC recognize a deceleration <2,5 m/s² (+/-0,5 m/s²) it will stop generating ESS.

Now my question is:
do you have access to single areas in BC memory?
I suggest to rise up the vehicle speed condition of >50km/h to e.g. 150 km/h or 200 km/h

I'm fully to your disposal and would like to help wherever it is possible.

Best regards
Luca

Hello yani,

any answer regarding this matter?

Best regards
Luca

Hello yani,

I don't want to be impolite, but I wrote you even a PN and didn't get any answer.
A simple yes or no would be enough.
I thought being a registered member would speed things up, but it doesn't look like.
Really a pity.

I now know which bit to change in the configuration to deactivate ESS but I don't know how to write it back in BC.
I'm not sure if you are interested in an solution in this issue. But for sure a lot of people will be interested in this and will be willing to pay even extra money for that.

Waiting for you feedback