Page 1 of 1
no working parameters?
Posted: 08 Apr 2012, 10:07
by fraguzz
hi
i cant get any of the parameters to show..
baude 9600
no software ver. no nothing..
it does connect and read fault codes
ELM 327 1.4
Re: no working parameters?
Posted: 08 Apr 2012, 10:10
by fraguzz
oh and i cant datalog them either not even rpm.. when chosen it just shows 0 in the graph..
tested the EGR acuvator and it did open an close!
Re: no working parameters?
Posted: 10 Apr 2012, 09:45
by Juggers2k
What car and what module are you connecting to?
Did the software give an invalid ISO code warning as it connected?
Re: no working parameters?
Posted: 10 Apr 2012, 20:18
by fraguzz
no errors.. id did say under test that this would not be able to connect to CAN
car fiat panda 1.3mjet 2004
elm327 1.4
choise 1.3+
Re: no working parameters?
Posted: 11 Apr 2012, 09:17
by Juggers2k
...and which module on the car are you connecting to?
Have you run a scan to check that the module you are selecting is the one reported as being present by the car?