Bug - Checking parameters during DPF regeneration

[Mazza-Engineering]

Hello,

not sure if already reported.
I use 2.8.2 and tried yesterday to do a regeneration of DPF on a Croma 2,4l.
Regeneration went fine, but I wanted to see the status in the parameter table.
But there was the window with "Work in progress" or similiar, and I couldn't close that(Yes, Esc, No) to go and see the parameters.
The pop up was still on top.
I had to cancel the task in task manager and restart FES, after that I could connect to the parameter page, during ecu doing regeneration.
Maybe I was doing something wrong, but maybe also a minor bug.

Just a small feedback.

Regards
Luca