Multiecuscan

Hello,

I'm getting this error and don't know if it's just a wrong adapter or if there's anything broken.

---
COMMAND: ATBI
RESPONSE: ERR94

WARNING: This interface is not compatible with ELM 327 1.3!
Will not connect to any CAN module.
---

This is what Multiecuscan 2.7.2 is telling me.

At the beginning the ATZ Command gets the answer: ATZELM327 v1.4a

Does Multiecuscan 2.7.2 not support ELM327 v1.4a Interfaces or am I doing anything wrong?

greetings
Andreas

Try to change port and do test.Maybe your elm interface is faulty.

hello,
i have the same problem with my elm 327 interface.did you found the problem?

thanks.

Try to remove this resistor connected between CAN-L and CAN-H.And if it does not work then the problem is elm327 chip.