Multiecuscan

hello friends

this sw support new protocol CAN to connect on alfa mtio ?

which interface ?

thank you

Will be in new realese.
For CAN you can use ELM327 v1.3+ or OBDKey ( not right now )
For OBDKey you'll need to wait when Yani will finish support for it.
Foe now I will advise to use an ELM327 v1.3+
Good luck

thank you friend

i have already vagcom interface , so i will test multiecuscan with vagcom interface

but i don't understand which modification must made on my cable.

vagcom interface need shint pins 1-7-9 ?
and pin 3 , i connect pin 3 with which pin ?

thank you

Pin 7 should be connected to Pin 1 and Pin 9 for engine, ABS, body

Pin 7 should be connected to Pin 3 is for Airbags.

Note Pin 7 is the ISO KKL signal pin.

IT IS NOT recommended to have both wiring modifications at the same time. That is 7 connected to 1,3 and 9.

I agree with s130!
more info you can find here: viewtopic.php?f=5&t=255!
Cheers