Multiecuscan

Hello i have used the last fiat ecu scan 2.2.1 and used ELM327 v 1.4, I can connect to the vehicle and i have choose the correct iso code ( BOSCHEDC16C39 CF4) my vehicle is (alfa 147 1.9 120hp jtdm).

The problem is i cant see lot's of parameters (Odometers, max rpm, particle filter and other) about 20 parameters cant read.

COMMAND: ATZ
RESPONSE: ATZ



ELM327 v1.4

>

COMMAND: ATE0
RESPONSE: ATE0

OK

>

COMMAND: ATL0
RESPONSE: OK

>

COMMAND: ATH0
RESPONSE: OK

>

COMMAND: ATSPC
RESPONSE: OK

>

COMMAND: ATS0
RESPONSE: OK

>

COMMAND: ATCAF0
RESPONSE: OK

>

COMMAND: ATCFC0
RESPONSE: OK

>

COMMAND: ATCRA 7B0
RESPONSE: OK

>

COMMAND: ATSH 7B0
RESPONSE: OK

>

COMMAND: ATAT1
RESPONSE: OK

>

COMMAND: ATST41
RESPONSE: OK

>

COMMAND: ATZ
RESPONSE:

ELM327 v1.4

>


Thanks

Does it show correct readings on the Info window?

Because there is a problem with the ELM interface which I already fixed in next version. It does not always read the ISO code, and might show empty/invalid ISO code as well as invalid reading for the other parameters. It is reported only on EDC16 ECUs.
If it is the same problem the you have to wait a week till the next release, or you can use VagCom interface.

Yani

Ok thanks yani . Yes i think it's show a correct reading.

HI i have the same problem i can't read odometer and other parameters.

I also have this problem (version 2.4.1)

Hi i have test the new version 2.5 and i have always the same problem. I can't read lots of parameters . I have elm327 1.4 link.
Please help me Yani

[Quote = "alfa147jtdm2008"] Ciao ho testare la Nuova versione 2.5 e ho semper Lo Stesso Problema. Non Riesco a leggere delle Nazioni Unite sacco di Parametri: cry:. Ho ELM327 1,4 link.
Please help me Yani:) [/ quote]