Multiecuscan

Hi Yani,
I haven't managed to connect using the 3-pin on 2 vehicles.
However when I scan DTC with 'optimal' KWP2000 with both high latency and normal modes this ecu shows up:
Other
UNKNOWN/UNSUPPORTED
ISO Code: 2F 86 01 94 1F

COMPLETED

Thanks & BR
Ralph

argtv6 wrote:Hi Yani,
I haven't managed to connect using the 3-pin on 2 vehicles.
However when I scan DTC with 'optimal' KWP2000 with both high latency and normal modes this ecu shows up:
Other
UNKNOWN/UNSUPPORTED
ISO Code: 2F 86 01 94 1F

COMPLETED

Thanks & BR
Ralph

This ISO code is correct for the hood module.
Please send me a report (from the red Send Report button in Multiecuscan) after a SCAN and after trying to connect to the hood module. I need this report to check why it cannot connect and why it says unsupported.

Hi Yani.
I will send you a report when I next have a 916 Spider at the workshop probably later this week.
Thanks & BR
Ralph

MES does not support Key / Immobiliser reprogramming.

I also believe that this function is unlikely to be be supported for security / safety / reliability reasons.

hi,
is it now supporting fiat sedici airbag system?

Yes, according to http://www.multiecuscan.net/SupportedVehiclesList.aspx

nope, still cant access sedici airbag system, can open it but thats as far as it goes, no further info...

any more ideas?

argtv6 wrote:Hi Yani.
I will send you a report when I next have a 916 Spider at the workshop probably later this week.
Thanks & BR
Ralph

Hi Yani,
Today I tried again with MES 1.5 and the 3 pin connector but no ecu was detected in the scan. I sent reports.
It seems that the option of connecting with the 3 pin in the battery compartment has gone with MES 1.5.
I've just ordered purple adaptor 4 from Gendan this evening and will try with that from the dash EOBD.
Thanks
Ralph

Hi everybody, I wanted to check my ABS for my ALFA GTV '97 (2.0 TS), and I got this error:
ABS
UNKNOW/UNSUPPORTED
ISO CODE: 6B 02 2A 10 7C.
Can anybody help me solving this problem?