Support version 1 Hitachi ECU - Fiat Barchetta

[litehead]

Hi,

I was happily surprised to hear about Multiecuscan. I own a Fiat Barchetta from 08/1995 which has the first Hitachi ECU version. As I understand it, there is partly support for 2nd version and full support for third version. I have bought a K-Line cable and a Fiat adaptor for the 3-pin Fiat service connector. However - I get absolutely no connection to the Hitachi ECU.

Before I give up totally, I would like to know, if you plan in some foreseable future to support also the old Hitachi ECU. If yes, when would you expect it to be supported. I would gladly pay for the prof. version if the support for my old Barchetta would only be included here.

Thanks in advance


- and keep up the good work!! You make a lot of Fiat people very happy.

regards, Peter

[litehead]

Hi Yani,

I'm sure you are very busy, but if you could just indicate if and when you plan to support the early versions of Hitachi ECU

Thanks in advance

[ivo_lalov]

Hi,

The same situation with Fiat Brava and Hitachi ECU. Is there a chance to have support of these ECUs?

Regards

[tox]

One more vote for support hitachi mpi ecu.
I have Fiat Brava 1.8 16v 1996 with hitachi ecu and it will be great if you can make support for this.
I think that with this support more people will be satisfied after me .

Best regard

[hitman142006]

Same thing here with a 1996 Fiat Coupe 1.8 16V with a Hitachi MFI-018.

[tox]

If i see good,in fiat ecu scan 2.7 hitachi mpi is suported?
Great job,man!
Can someone just verify that all I need for conecting to my Brava 1.8 16v is Fiat Ecu scan,elm 327 and 3 pin to obd adapter?

One more time,thanks!