Fiat Bravo t-jet 1.4 110 kw 2007

[TomBravo]

Hi,

I'm new here and wanted to introduce myself.

I am from Germany and drive a fiat bravo t-jet kw 110.

Can you give me a tip what hardware do I need to read the motor data and deliver the service intervall back?

Is it posible?

Greeting
Tom

[EnIgMa]

Hi there,
there are a lot of thread about it, just take a look.

An elm 1.3a or newer device should be fine for you.

[alfa156sarajevo]

I agree with EnIgMa.
You need ELM327 v1.3 or newer!
Cheers!

[TomBravo]

Hi,

I've bought a ELM 327 Interface. Unfortunately, I get not connect.

It is recognized an unknown ECU in scan mode. Nothing else.

With ScanXL software I can read data from the car. With multiecuscan nothing go.

When testing is everything as shown o.k

I want to reset my Service-Intervall ((((((((((


Is it a bug with t-jet?


COMMAND: ATZ
RESPONSE: ATZ



ELM327 v1.4

>

COMMAND: ATE0
RESPONSE: ATE0

OK

>

COMMAND: ATL0
RESPONSE: OK

>

COMMAND: ATH0
RESPONSE: OK

>

COMMAND: ATSPC
RESPONSE: OK

>

COMMAND: ATS0
RESPONSE: OK

>

COMMAND: ATCAF0
RESPONSE: OK

>

COMMAND: ATCFC0
RESPONSE: OK

>

COMMAND: ATCRA 7B0
RESPONSE: OK

>

COMMAND: ATSH 7B0
RESPONSE: OK

>

COMMAND: ATAT1
RESPONSE: OK

>

COMMAND: ATST41
RESPONSE: OK

>

COMMAND: ATBI
RESPONSE: OK

>

COMMAND: ATZ
RESPONSE:

ELM327 v1.4

>

[yani]

I saw one report from BRAVO '07 and I guess it is from you.
Your interface cannot connect to anything on CAN network which means that it is probably faulty. You cannot reset the service interval without CAN.
You can connect to the engine because it is not on the CAN network. However, your engine is not supported yet, so the program shows UNKNOWN.
You cannot connect to the ABS and EPS because you need to modify your interface.