Service Reset using MultieCuScan - Fiat Panda 4x4 1.2 MultiJet 16v

General support messages
Post Reply
XtractorFan
Posts: 2
Joined: 28 Aug 2023, 14:21

Service Reset using MultieCuScan - Fiat Panda 4x4 1.2 MultiJet 16v

Post by XtractorFan »

Back in July 23 I purchased a Fiat Panda for my wife, I didn't trust the Garage selling it, but she fell in love with the car.....
The last service receipt was for May 23 - but not entered into the service log book, so I didn't trust it.
An oil and all filter change didn't inspire more confidence, but the car ran OK subsequently.
I purchased MultieCuScan and Cable adaptor 3 (yellow) and thought I'd done the Service Reset thing and the service warning went away.
But a few days ago it flashed up that a service was required - it's now down to 13 days left.

Image

Now I can't remember how I reset the warning as I'm a geriatric.....
Connecting and running MCS gives me the following:

Image
Image
Image
Image
Image
Image

I was surprised to see Last Service Date is 05/05/2023 (the last garage service date) not when I did the service and reset on around 25/08/2023.
So I probably didn't do the Service Reset properly.

So can anyone tell me what to change when I service the car again?
Thanks
abarthmultijet
Posts: 166
Joined: 17 Feb 2021, 22:37
Location: Oss, Netherlands

Re: Service Reset using MultieCuScan - Fiat Panda 4x4 1.2 MultiJet 16v

Post by abarthmultijet »

You also need to reset oil change in the engine tab.
Jeep Compass 4XE, Fiat Doblo 263 1.4 t-jet, Audi S4 B8.5, 1.3 Multijet specialist, Uconnect 7 specialist,
Post Reply