Removind Electronic Steering module out of ecu Panda 169 2010

[patjes]

Dear MultiEcuScan loivers and users. I have puchased a license yesterday so the programm fully works
My question is i hava a 2010 fiat panda 169 euro 5 with 1.2 engine 69hp, removed the electrical steering to replaced with a none electric steering. (trackday related) Mechanicly everything works fine, but i want to know if it is possible to remove the eps out of de ecu so the warning light doesnt show up, Thank you for your time and effort

[patjes]

Turned out to be very easy. :ROFLMAO: with original Multiecuscan software registered, and a good elm327 dongle.
No adaptercables needed
Removed the powercables from the power steering. So the light of fault EPS turned on, left the datacables intact on the eps-ecu.
New proxi alignment procedure,save, and now it says : powersterring not present, no erros or fault codes, and the city knob is deactivated,
Scanning for fault codes,
No faultcodes turn up, yes, yes, Yes