I don`t know if it is possible but here is my request;
I know the connect Nav has a CAN-bus connection, so could it be possible to do some diagnostic on the connect nav+?
Connect Nav+
Re: Connect Nav+
Connect Nav+ has it's own (hidden) diagnostic menu.
1 Press "SETUP".
2 Press "CONNECT" (button 10, 11 or 12 along the bottom of the screen).
3 Wait one second, then press "CONNECT" 3 times.
4 Press "ENTER".
5 A new button labeled "SERVICE" or "AID" should appear on the screen.
6 Scroll down the the new button and press "ENTER"
7 Four pages of diagnostic information should appear.
1 Press "SETUP".
2 Press "CONNECT" (button 10, 11 or 12 along the bottom of the screen).
3 Wait one second, then press "CONNECT" 3 times.
4 Press "ENTER".
5 A new button labeled "SERVICE" or "AID" should appear on the screen.
6 Scroll down the the new button and press "ENTER"
7 Four pages of diagnostic information should appear.
Re: Connect Nav+
Yes i know that. But I think it could be possible that there are other options available through CAN-bus connection. But Yani can make this clear i hope?