Do I have to pay $50 for someone to Help me here?

[Abarther193]

Jesus no one responds here whats the point of this forum, if that's the case I'll pay anybody that can help me solve my issue.

[alex-et3]

Qual é il tuo problema?

[Abarther193]

I have a 2013 fiat 500 (American Model) and I replaced my stock cluster with a 2014 prestyling tft digital cluster with blue & me connect so I got the exact one needed. I purchased the complete multiecuscan kit with cables and registered software and followed all the instructions......Body connect ......in the next screen
cont, alt C for or hidden proxy settings screen.......byte 65 ..00 to 60 press ok ...Go to proxy ailing and execute...turn the car off when finished wait a minute then turn the car back on and NOTHING still the same base 500 mode (00) but when i go to check the proxy the 60 is still there so I'm stuck with the crappy 500 cluster theme.

[alex-et3]

most likely the proxy alignment is not successful in the tft. it will be an elm interface problem. the same problem happened to me on a UCONNECT. Don't have another diagnosis program?

[Abarther193]

Like which one? I'm using MES.

[Abarther193]

I'm using the red elm interface that came with the MES kit? So the one they provided doesn't have the mod already on it....the 120 pin removal?

[alex-et3]

Like which one? I'm using MES.

try going to a repair shop and having proxy alignment done

[Abarther193]

In mes it says that everything is configured properly and that it's not necessary when I connect to the car though and my milage is not flashing anymore, it was when I first connected it but not now.

[alex-et3]

In mes it says that everything is configured properly and that it's not necessary when I connect to the car though and my milage is not flashing anymore, it was when I first connected it but not now.

he said so to me too ....

[Abarther193]

So you went to a dealer or to your mechanic?