Unstable idle after using Multiecuscan on Lancia Thesis

Phaeton_82 · Post by **Phaeton_82** » 16 May 2020, 08:59

Hello,

I have a Lancia Thesis 2.0 TB and I always have a problem after using Multiecuscan. When I turn on the car after using Multiecuscan, it always have an unstable idle, even turning off by itself. And that happens a few days until it disappears and the idle is stable again. But if I connect Multiecuscan, the cycle repeats again.

What can be happening? When I connect to the engine ECU, it always appears the same permanent error, I've attached the last log to this post. Also, when I connect Multiecuscan, several indicators light on in the dashboard, specifically those related to the braking system (ABS, EPB, ESP) and I think this is not normal either.

Someone has the same problem? If you can help me, I'll apreciatte it very much

Thank you!