injector coding issue fiat punto Van

[F50]

Hi everybody,

I am new here, I recently buy this program, for the injector programming of a fiat punto 1.3 jtd.

I got a elm interface 1.3+, and try to get the injector coded. all goes well, till i get to the point for saving the new data.
I get the message "interface not compatible"

Can somebody give me a glimps to what i do wrong?

In the list of the cars's compatible functions, i see the KL ELM to be compatible with the Marelli injection system,
so i can be sure it should work?


Marelli 6JF EOBD Diesel Injection (1.3) |INFO|DTC|DTC EX|PRM|ACT|ADJ| KLELMOBDKey
Marelli SELESPEED CFC208F (1) Automatic Gearbox |INFO|DTC|DTC EX|PRM|ACT|ADJ| KLELMOBDKey
Bosch ABS 8 |INFO|DTC|DTC EX|PRM|ACT| KL 1ELM 1OBDKey 1 A1
Bosch ABS 8 VDC |INFO|DTC|DTC EX|PRM|ACT|ADJ| KL 1ELM 1OBDKey 1 A1
TRW MY97 Airbag (2F-2L-I) |INFO|DTC|PRM| KL 3OBDKey 3 A2
TRW MY97 Airbag (2F-I) |INFO|DTC|PRM| KL 3OBDKey 3 A2
TRW MY99 Airbag (2F-2L-2T-I) |INFO|DTC|PRM|ACT| KL 3OBDKey 3 A2
TRW MY99 Airbag (2F-2T-I) |INFO|DTC|PRM|ACT| KL 3OBDKey 3 A2
Delphi Electric Steering |INFO|DTC|PRM|ACT|ADJ| ELMOBDKey
Service Interval Reset (Base) |INFO|ADJ| ELMOBDKey
Service Interval Reset (Comfort) |INFO|ADJ| ELMOBDKey
Instrument Panel Marelli (Base) |INFO|DTC|PRM|ACT|ADJ| ELMOBDKey
Instrument Panel Marelli (Comfort) |INFO|DTC|PRM|ACT|ADJ| ELMOBDKey
Body Computer Delphi/Marelli (188) |INFO|DTC|PRM|ACT|ADJ| ELMOBDKey
Body Computer Marelli (188FL) MY03 |INFO|DTC|DTC EX|PRM|ACT|ADJ| ELMOBDKey
CAN Info |INFO| ELMOBDKey
CAN Info |INFO| ELMOBDKey
CAN Setup / PROXI Alignment Procedure |INFO|ADJ| ELMOBDKey
CAN Setup / PROXI Alignment Procedure |INFO|ADJ| ELMOBDKey
Denso climate control (Dual zone) |INFO|DTC| ELMOBDKey

[F50]

Nobody have any idea?

[F50]

For future people that have the same issue and allso get zero input on this forum, i found the problem.

For the injector coding you need to use a KL cable, not a ELM327.
For some reason it only works with a KL. Any simple cheap vagcom cable will do.
Dont forget to set the latency to minimum and the speeds to maximum in your cable device options.

cheers,

[alfa156sarajevo]

That's right. Injector coding works only with KKL or KL interface.
ELM can not do the job...

Sorry I would helped you but I am not always online...