Cable for Fiat punto III 1.9 JTD 2004

[johnnyferrari]

Hi all,
I'm italian and, then, sorry me for my incorrectly english.
I have a fiat punto III 1.9 jtd 2004 and would like to use multiecuscan to reset errors.
What cable do i use?
I've seen a photo with 4 clabes (i post you the photo)

Cable 1 is OBD cable
Cables 2 are adapters
Cable 3 is KL cable
Cable 4 is 16 pin cable
Right?
The table for my car is the following:

Therefore, what cable do i use for reset errors in my car?

[KoCMoHaBTa]

Hi,

You could look at the legend at the top of the page from where you get the table for your car.
Anyway in order to connect to the engine - you will need either cable 1 or 3, where cable 1 is represente as green ELM tag and cable 3 is represented as blue KL tag.

The adapters are used alongisde cable 1 or 3 in order to connect to other control modules of your car, like ABS or Airbag.

Also take in mind that there a lot of faulty cheap ELM 327 interfaces (cable 1), so you should probably look into that topic too.
I guess that cable 3 does not suffer from such problems.

[johnnyferrari]

Hi KoCMoHaBTa,
First of all, thanks for your answer. I'll buy the kl cable
I want to ask another question...
The version of my multiecuscan is 1.4. It's okay?
Therefore, i need the following things to reset errors:
1-pc
2-multiecuscan 1.4
3-kl cable
Exact?

[KoCMoHaBTa]

Yes, it should be ok.
You can also download the latest version (2.8) from the web site.