Fail reseting the oil indicator

[apere]

Hello!

I'm trying to reset the Oil replacement indicator with the registered version of Multiecuscan I bought a few hours ago...

I'm using an ELM327 officially ver 1.4. I can connect it and see all the parameters displayed with no problem.

When I try to reset the oil degradation indicator, multiecuscan tells me that the modification goes well, and I got no error. But when I start the engine, the oil light continues to blink as it was doing before, and the parameters displayed in multiecuscan (oil degradation) stays the same...

I don't know what to do to deal with this issue....

Can you help me?

[alfa156sarajevo]

In general Oil resetting is done in engine ECU and service interval ECU.
Until you reset both service messages in engine ECU and service interval you will have that problem.