fiat marea jtd

[shop soiled]

hi everyone
I have a fiat marea weekend 1.9JTD, 2001
I purchased a ob2 cable and downloaded your software but for some reason
Cannot connect to ecu. I have followed your instructions for setup.
My laptop hp nx9010 p4 2.6g using the vag-com has set up usb port com 3 and
The led on cable plug lights up: pin 7 on the 16 pin car diagnostic socket is
Populated so has pin 7 on the 16 pin plug, when I try to connect after selecting
The vehicle the software message connecting comes up for around 10 seconds
And message bottom left says disconnected. Any help would be gratefully received.

recomended here from fiat forum

[topogatto]

do you have tried to connect your pc/cable to another car?

[alfa156sarajevo]

did you install all the needed drivers?

[shop soiled]

do you have tried to connect your pc/cable to another car?

hi no i have not tried that, it could be the cable (new one) just need to find a fiat,
or something to simulate on. len

[shop soiled]

did you install all the needed drivers?

only those drivers that were on the vag com disc. len

[alfa156sarajevo]

first:
you should install on you laptop Microsoft .NET Framework version 2.0
link:
http://www.microsoft.com/downloads/deta ... laylang=en

second:
you should install FTDI drivers version 2.06.00
link:
http://www.ftdichip.com/Drivers/VCP.htm

third:
you should open http://www.multiecuscan.net/HowToUse.aspx and follow the instructions

P.S. don't forget to restart your computer after installation of different drivers!
olso please read topic: viewtopic.php?f=5&t=255