activate cruise control on alfa mito 1.6 jtdm 120cv

[mpaocetul]

Hi! I have multiecuscan 1.3 registered and an elm327 with adapter 3. I would like to know if it is possibile to activate the cruise control on an alfa Romeo mito 1.6 jtdm 120cv year 2008. Thanks so much.

[Alfaeddy]

Hello mpaocetul

Have you installed a cruise control later?

The key function in the body computer you can check parameters
Power Button
Set +
Set -

Otherwise, a proxy alignment (Can setup) should also be able to assist.

Greetings Eddy

[mpaocetul]

Hi! Yes i ha ve installed a cruise control aftermarket! I don't understand what you told me because i ma italian can you explain in simpler words? excuse me and thanks again. PS. I know that there are tip up tip down and rest button but i haven't understood the other parte if tour message

[Alfaeddy]

Ciao

Impostare un link per la configurazione del controller CAN fa
andare alle impostazioni (F7) e provare un
Proxi Alignment


Ma se non c'è il cruise control originale, questo è probabilmente non aiuta

Saluti Eddy

google translate

[mpaocetul]

If i have understood i have to center in can setup band activate cruise control. Then do the proxy allignement. Right? I know the procedure but i asked if multiecuscan can do if. If mito si supported.
Thanks

[Alfaeddy]

Hi

Its an original Cruise Control ???



Greetings Eddy

[mpaocetul]

Yes sure! Original but installed aftermarket

[Alfaeddy]

Hi

Then test it for the Proxi Aligment


Greetings Eddy

[mpaocetul]

Who can explain me the self-learning function of multiecuscan?

[Alfaeddy]

Hello

You mean the self-learning function for the interface?

This is usually automatically

- Interface in USB plug
- Installing drivers
- Interface in OBD connector plug
- Multiecuscan start
- MES / Settings / Interface / scan interface


But will still be set manually the Latency Time to 1

Greetings Eddy