Hello, I bought the cable elm 327 1.4v with the program multiecuscan licensed for my stilo mjet 120cv 2006. I was able to enable the fog lights to my car, to make alignment proxy for the fog lights and both the connect nav +. and everything works great! I try to do the procedure F11 SCAN and F12 SCAN DTC but no data appears when the procedure ends! I can not get into the engine control unit! if you do not need any adapter, you only need the cable elm 327, to enter the engine control unit as also shown in multiecuscan site, what's the problem?
I hope someone help me
Help with elm 327
Re: Help with elm 327
Please, someone can help me?
Re: Help with elm 327
Hello
A friend of mine was also read out a Fiat Stilo,
And can not connect to this Stilo.
I have ELM interface now check with me to get it
In a few days I might say something about that?
Sorry, but it takes a few more days
Greetings Eddy
A friend of mine was also read out a Fiat Stilo,
And can not connect to this Stilo.
I have ELM interface now check with me to get it
In a few days I might say something about that?
Sorry, but it takes a few more days
Greetings Eddy