ISO Codes

Report any bugs found in Multiecuscan and suggest new functionality to be implemented
Post Reply
devc
Posts: 31
Joined: 13 Feb 2010, 20:34
Location: South Africa
Contact:
Contact devc

ISO Codes

Post by devc »

Hi Yani,
I notice in Fiat Examiner there is a option: "Ignore ISO Codes"
I think, if one can ignore the ISO codes, one can access more control units with the same communications procedures.
It may be worthwhile to look into that for your new version.
Thanks, you have been doing a fantastic job so far!
Regards,
Dev
Top
yani
Site Admin
Posts: 1173
Joined: 06 Nov 2009, 16:40

Re: ISO Codes

Post by yani »

You CAN ignore ISO codes. Just press Y when the program shows the mesage "Invalid ISO Code! Press Y To Continue or Press N To Abort".

Yani
Top
devc
Posts: 31
Joined: 13 Feb 2010, 20:34
Location: South Africa
Contact:
Contact devc

Re: ISO Codes

Post by devc »

Oops, have not seen that yet. Sorry!
Regards, Dev
Top
ARomeo
Posts: 97
Joined: 06 Jan 2010, 10:45

Re: ISO Codes

Post by ARomeo »

yani wrote:You CAN ignore ISO codes. Just press Y when the program shows the mesage "Invalid ISO Code! Press Y To Continue or Press N To Abort".

Yani
I pressed Y, but I coucn't see values of parameters
Top
Post Reply

Return to “Bugs and Feature Requests”