Multiecuscan

I have installed the drivers for an ELM 327 cable that I purchased. It shows up fine in device manager as well.

I installed version 2.1 of Multiecuscan and set it up to use ELM 327 as stated here - http://www.multiecuscan.net/HowToUse.aspx . I am unable to find the "Test" option to check if the ELM 327 interface responds to the commands. Is there something I am missing here?

The "Test" function is in Multiecuscan 2.2.1.

Yani

Thanks Yani. Downloading the latest version now. I was able to connect successfully. I'll evaluate the product and place an order soon.