Multiecuscan

Hi there!
I’ve connected FES 2.1 free to my Punto ’99 1.2 8v via a VAG COM cable.
When I try to connect I get the message “Invalid ISO code, press Y to Continue or Press N to Abort”. No matter which of the three ECU options I choose on the main page: “TRW MY 97 Airbag(2F-2L-I)” or “TRW MY 97 Airbag(2F-2L-2T-I)” or“ TRW MY 97 Airbag(2F-I)”.

These are the parameters shown by FES:
- ECU ISO code: 26 86 9B 02 9E
- FIAT drawing number: 00 51 71 18 16
- Hardware version: 1.4
- Software version: 0.7
- ECU programming date: 01/01/2003

I can connect to engine but I can’t connect to airbag.How can I do?
It is big problem when I don’t do pin?
Thanks

i ave also tested my elm 327 interface on a '99 punto mk2 1.2 8v, the screenshoot " invalid ISO etc.." was displayed.. I thin beacuse the standard eobd is activated later 2000 year..