Multiecuscan

Jesus no one responds here whats the point of this forum, if that's the case I'll pay anybody that can help me solve my issue.

Qual é il tuo problema?

I have a 2013 fiat 500 (American Model) and I replaced my stock cluster with a 2014 prestyling tft digital cluster with blue & me connect so I got the exact one needed. I purchased the complete multiecuscan kit with cables and registered software and followed all the instructions......Body connect ......in the next screen
cont, alt C for or hidden proxy settings screen.......byte 65 ..00 to 60 press ok ...Go to proxy ailing and execute...turn the car off when finished wait a minute then turn the car back on and NOTHING still the same base 500 mode (00) but when i go to check the proxy the 60 is still there so I'm stuck with the crappy 500 cluster theme.

most likely the proxy alignment is not successful in the tft. it will be an elm interface problem. the same problem happened to me on a UCONNECT. Don't have another diagnosis program?

Like which one? I'm using MES.

I'm using the red elm interface that came with the MES kit? So the one they provided doesn't have the mod already on it....the 120 pin removal?

Abarther193 wrote: ↑07 Jan 2021, 21:36 Like which one? I'm using MES.

try going to a repair shop and having proxy alignment done

In mes it says that everything is configured properly and that it's not necessary when I connect to the car though and my milage is not flashing anymore, it was when I first connected it but not now.

Abarther193 wrote: ↑07 Jan 2021, 22:10 In mes it says that everything is configured properly and that it's not necessary when I connect to the car though and my milage is not flashing anymore, it was when I first connected it but not now.

he said so to me too ....

So you went to a dealer or to your mechanic?