Multiecuscan

Dear everybody,

The system shows me the error ( Dashboard Node (NQS): EOL Failed ) and the engine stopped working.

Reading CAN configuration data ...
CAN CONFIGURATION DATA:
6F 00 00 04 00 00 00 00 6F 00 00 04 00 00 00 00 4B 00 00 00 00 00 00 00 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
6F 00 00 04 00 00 00 00 09 00 00 04 00 00 00 00 6F 00 00 04 00 00 00 00 09 00 00 04 00 00 00 00 01 00 00 04 00 00 00 00
33 38 31 39 39 30 33 33 37 37 33 4F 55 54 50 55 54 2D 4A 49 54 20 12 01 19 6F 00 00 04 00 00 00 00 09 00 00 04 00 00 00 00 48 C0 73 07 58 00 2A 21 A3 90 00 06 00 07 00 8C 06 0B 02 46 00 01 81 00 35 40 0A 0C 0D 00 00 00 21 00 00 00 00 11 01 60 01 20 00 00
Body Computer Node (NBC)
Engine Control Node (NCM)
Electric Steering Node (NGE)
Dashboard Node (NQS)
Receiver Radio (NRR)
Brake System Node (NFR)
Airbag Node (NAB)
21-10-2020 19:10:57
CONNECTED TO:
Fiat Punto 2012 1.3 Multijet 16V
CAN Setup / PROXI Alignment Procedure

Body Computer Node (NBC): EOL Ok
Engine Control Node (NCM): Ok
Electric Steering Node (NGE): Ok
Dashboard Node (NQS): EOL Failed
Receiver Radio (NRR): Ok
Brake System Node (NFR): Ok
Airbag Node (NAB): EOL Ok

EXECUTING ADJUSTMENT...
PROXI ALIGNMENT PROCEDURE
Writing CAN configuration data ...
Writing to module: Body Computer Node (NBC) SUCCESS!
Writing to module: Dashboard Node (NQS) SUCCESS!
Writing to module: Airbag Node (NAB) SUCCESS!
COMPLETED

I don't know where I went wrong. I think I need help

I have same problem on Fiat Panda. Do you know something more? Thanks.